Fuel Sender Gauge Assembly (For 2Az-Fe) Installation

Slide the fuel sender gauge to fit the claw.

Connect the fuel sender gauge connector.

Install a new gasket to the fuel suction tube.

Install the fuel suction tube.

NOTICE:

1. Do not damage the fuel pump filter.
   
2. Be careful that the arm of the sender gauge does not bend.
   

Align the mark of the set plate with the fuel suction tube.

Install the set plate with the 8 bolts.

Torque:

5.9 N*m{60 kgf*cm, 52 in.*lbf}

Install the fuel pump tube with the tube joint clip.

NOTICE:

1. Check that there are no scratches or foreign objects on the connecting part.
   
2. Check that the fuel tube joint is inserted securely.
   
3. Check that the tube joint clip is on the collar of the fuel tube joint.
   
4. After installing the tube joint clip, check that the fuel tube joint is pulled off.
   

Connect the fuel pump connector.

Install the rear floor service hole cover with new butyl tape.

Attach the front hooks of the bench type rear seat cushion assembly to the vehicle body.

Confirm that the seat cushion is firmly installed.

NOTICE:

When installing the bench type rear seat cushion assembly, make sure that the seat belt buckle is not under the bench type rear seat cushion assembly.

Attach the front hooks of the bench type rear seat cushion assembly to the vehicle body.

Confirm that the seat cushion is firmly installed.

NOTICE:

When installing the bench type rear seat cushion assembly, make sure that the seat belt buckle is not under the bench type rear seat cushion assembly.