Meter / Gauge System Data List / Active Test

Body Electrical. Camry. Acv40 Gsv40
Meter. Camry. Acv40 Gsv40

  1. DATA LIST

  1. ACTIVE TEST

Meter / Gauge System -- Data List / Active Test



DATA LIST
According to the Data List displayed by the intelligent tester, you can read the values of the switches, sensors, actuators and so on without parts removal. Reading the Data List as the first step of troubleshooting is one method to shorten work time.

  1. Warm up the engine.

  2. Turn the ignition switch off.

  3. Connect the intelligent tester to the DLC3.

  4. Turn the ignition switch to the ON position.

  5. Turn the tester ON.

  6. Enter following menus: Diagnosis / OBD/MOBD / Combination Meter / Data List.

  7. Check values by referring to the table below.

    Combination Meter:
    Tester Display
    		Measurement Item/Range
    		Normal Condition
    		Diagnostic Note
    Tail Cancel SW
    		TAIL CANCEL switch is ON/OFF
    		ON: Rheostat knob turns fully clockwise
    		-
    OFF: Rheostat knob turns fully counterclockwise
    		-
    ODO/TRIP Change SW
    		ODO/TRIP switch is ON/OFF
    		ON: Switch is pushed
    		-
    OFF: Switch is released
    		-
    P-Seatbelt Buckle SW
    		Front passenger buckle switch is ON/OFF
    		ON: Seat belt is fastened
    		-
    OFF: Seat belt is unfastened
    		-
    Vehicle Speed Meter
    		Vehicle speed/Min.: 0 km/h (0 mph), Max.: 255 km/h (158 mph)
    		Almost same as actual vehicle speed (When driving)
    		If data received from the skid control ECU exceeds the range that can be displayed on the meter, the meter continues to display the maximum value of the range.
    Engine Rpm
    		Engine speed/Min.: 0 rpm, Max.: 12,750 rpm
    		Almost same at the meter rpm (When engine is running)
    		If data received from the ECM exceeds the range that can be displayed on the meter, the meter continues to display the maximum value of the range.
    Coolant Temperature
    		Engine coolant temperature 0°C (32°F) to 127.5°C (261.5°F)
    		After warming up: 78°C (172.4°F) to 105°C (221°F)
    1. If -40°C (-40°F): sensor circuit open
    1. If 140°C (284°F) or more: sensor circuit shorted
    Washer Switch
    		Washer level warning switch is ON/OFF
    		ON: Washer level is more than low
    		-
    OFF: Washer level is less than low
    		-
    Multi Display Select Switch
    		MODE switch in the steering pad is ON/OFF
    		ON: Mode switch is ON
    		-
    OFF: Mode switch is OFF
    		-
    +B Voltage Value
    		Battery voltage/Min.: 0 V, Max.: 25.5 V
    		10 to 14 V
    		-
    Fuel Input
    		Fuel input signal Min.: 0, Max. 255
    		Fuel gauge indicates (F): 35
    		-
    Fuel gauge indicates (3/4): 85
    		-
    Fuel gauge indicates (1/2): 145
    		-
    Fuel gauge indicates (1/4): 186
    		-
    Fuel gauge indicates (E): 205
    		-
    Ambient Temperature
    		Outside temperature: Min.: -40°C (-40°F) to 87.5°C (189.5°F)
    		Almost same as actual outside temperature
    		The temperature displayed on the multi-information display is -22 to 122°C (-30 to 50 °F)
    Rheostat value
    		Light Control Rheostat/Min.: 0, Max.: 100
    		Light control rheostat switch is Dark (0) → Bright (100)
    		-
    Quantity of Outside Light
    		Light Control Rheostat/Min.: 0, Max.: 255
    		Light control rheostat switch is Dark (0) → Bright (100)
    		-
    Communication ECM/Meter DTC 1 to 3
    		Value when DTC is output Min.: 0, Max.: 999999
    		-
    		-
    ECM ODO (History 1 to 3)
    		Value when DTC is output Min.: 0, Max.: 999999
    		-
    		-
    Communication ABS/Meter DTC 1 to 3
    		Value when DTC is output Min.: 0, Max.: 999999
    		-
    		-
    ABS/VSC ODO (History 1 to 3)
    		Value when DTC is output Min.: 0, Max.: 999999
    		-
    		-
    Key Remind Sound
    		The cycle of the key reminder warning buzzer is Fast, Normal, Slow
    		The customized setting of the cycle of the key reminder warning buzzer is displayed.
    		-
    Seat-belt Warning Buzzer
    		The volume of the seat belt warning buzzer is D/P ON, D ON, P ON, D/P OFF
    		The customized setting of the volume of the seat belt warning buzzer is displayed.
    		-
    Key Remind Volume
    		The volume of the key reminder warning buzzer is Large, Medium, Small
    		The customized setting of the volume of the key reminder warning buzzer is displayed.
    		-

    ABS/TRAC/VSC:
    Tester Display
    		Measurement Item/Range
    		Normal Condition
    		Diagnostic Note
    FR/FL/RR/RL Wheel Speed
    		Vehicle speed/Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph)
    		Almost same as actual vehicle speed (When driving)
    		-
    Vehicle Speed
    		Vehicle speed/Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph)
    		Almost same as actual vehicle speed (When driving)
    		-

    Engine:
    Tester Display
    		Measurement Item/Range
    		Normal Condition
    		Diagnostic Note
    Engine Speed
    		Vehicle speed/Min.: 0 rpm, Max.: 16,383.75 rpm
    		Almost same as actual engine speed (When driving)
    		-
    Coolant Temp
    		Engine coolant temperature:
    Min.: -40°C (-40°F), Max.: 140°C (284°F)
    		80 to 100°C (176 to 212°F):
    After warming up
    1. If -40°C (-40°F): sensor circuit open
    1. If 140°C (284°F) or more: sensor circuit shorted


ACTIVE TEST
Performing the Active Test using the intelligent tester allows the meters, indicators and so on to operate without parts removal. Performing the Active Test as the first step of troubleshooting is one way to shorten labor time.
It is possible to display the Data List on the intelligent tester during the Active Test.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch to the ON position.

  3. Turn the tester ON.

  4. Enter following menus: Diagnosis / OBD/MOBD / Combination Meter / Active Test.

  5. From the display on the tester, performing the "Active Test".

    Combination Meter:
    Tester Display
    		Test Part
    		Control Range
    		Normal Condition
    Speed Meter Operation
    		Speedometer
    		0, 40 (24), 80 (48), 120 (72), 160 (96), 200 (120) km/h (mph)
    		-
    Tacho Meter Operation
    		Tachometer
    		0, 1,000, 2,000, 3,000, 4,000, 5,000, 6,000, 7,000 (rpm)
    		-
    Fuel Meter Operation
    		Fuel receiver gauge
    		EMPTY, 1/2, FULL
    		-
    Water Temperature Meter Operation
    		Engine coolant temperature receiver gauge
    		LOW, NORM, HIGH
    		-
    A/T Indicator Operation 1 (*1)
    		A/T shift indicator light
    		A/T shift indicator light L, 2, 3, 4, S, D, N, R, P is OFF/ON
    		-
    A/T Indicator Operation 2 (*1)
    		A/T gear range indicator light
    		A/T gear range indicator light is OFF/ON
    		-
    Meter Display 1
    		Multi-information display
    		All the dot in the multi-information display OFF/ON
    		Confirm that the vehicle is stopped, engine idling
    Meter Display 2 (*1)
    		A/T shift indicator display
    		All the dot in the A/T shift indicator display OFF/ON
    		Confirm that the vehicle is stopped, engine idling
    Indicat. Lamp Airbag
    		SRS warning light
    		SRS warning light is OFF/ON
    		-
    Indicat. Lamp Doors All Open
    		Open door indicator
    		Open door indicator is OFF/ON
    		-
    Indicat. Lamp P-seat Belt
    		P-belt indicator light
    		P-belt indicator is OFF/ON
    		-
    Indicat. Lamp D-seat Belt
    		D-belt indicator light
    		D-belt indicator is OFF/ON
    		-
    Indicat. Lamp ABS
    		ABS warning light
    		ABS warning light is OFF/ON
    		Confirm that the vehicle is stopped, engine idling
    Indicat. Lamp Charge
    		Charge warning light
    		Charge warning light is OFF/ON
    		-
    Indicat. Lamp Slip (*2)
    		Slip indicator light
    		SLIP indicator is OFF/ON
    		-
    Indicat. Lamp Beam
    		Hi-beam indicator light
    		Hi-beam indicator is OFF/ON
    		-
    Indicat. Lamp Tail
    		TAIL indicator light
    		TAIL indicator is OFF/ON
    		-
    Indicat. Lamp Fr FOG
    		Fr FOG indicator light
    		Fr FOG indicator light is OFF/ON
    		Confirm that the vehicle is stopped, engine idling
    Indicat. Lamp Rr FOG
    		Rr FOG indicator light
    		Rr FOG indicator light is OFF/ON
    		Confirm that the vehicle is stopped, engine idling
    Indicat. Lamp D Door Open
    		D DOOR OPEN indicator light
    		D DOOR OPEN indicator light is OFF/ON
    		Confirm that the vehicle is stopped, engine idling
    Indicat. Lamp P Door Open
    		P DOOR OPEN indicator light
    		P DOOR OPEN indicator light is OFF/ON
    		Confirm that the vehicle is stopped, engine idling
    Indicat. Lamp RR Door Open
    		RR DOOR OPEN indicator light
    		RR DOOR OPEN indicator light is OFF/ON
    		Confirm that the vehicle is stopped, engine idling
    Indicat. Lamp RL Door Open
    		RL DOOR OPEN indicator light
    		RL DOOR OPEN indicator light is OFF/ON
    		Confirm that the vehicle is stopped, engine idling
    Indicat. Lamp Luggage Door Open
    		LUGGAGE DOOR OPEN indicator light
    		LUGGAGE DOOR OPEN indicator light is OFF/ON
    		Confirm that the vehicle is stopped, engine idling
    Indicat. Lamp Fuel
    		Fuel warning light
    		Fuel warning light is OFF/ON
    		-
    Indicat. Lamp ECB
    		Brake warning light
    		BRAKE warning light is OFF/ON
    		Confirm that the vehicle is stopped, engine idling
    Indicat. Lamp Cruise
    		Cruise indicator light
    		CRUISE indicator is OFF/ON
    		-
    Indicat. Lamp Brake
    		Brake warning light
    		BRAKE warning light is OFF/ON
    		Confirm that the vehicle is stopped, engine idling
    Master Warning
    		Master caution indicator light
    		Master caution indicator light is OFF/ON
    		Confirm that the vehicle is stopped, engine idling
    *1: for Automatic Transaxle
    *2: with VSC

    Main Body
    Tester Display
    		Test Part
    		Control Range
    		Normal Condition
    Dimmer signal
    		Dimmer signal
    		Dimmer signal is OFF/ON
    		-