Wiper And Washer System System Description

The wiper and washer system may have some of the following functions:

The windshield wiper relay assembly (auto wiper relay) controls the wiper system.

General

1. The raindrop sensing function controls the wiper timing in accordance with the amount of raindrops that strike the windshield glass when the windshield wiper switch assembly is in the AUTO position.
   

   1. The windshield wiper relay assembly (auto wiper relay) adjusts the wiper timing based on commands from the rain sensor. These adjustments are based on vehicle speed and a determination of the vehicle driving and stopping conditions during automatic operation.
      
   2. The windshield wiper relay assembly (auto wiper relay) adjust the wiper timing based on command from main body ECU. This regulation is adjusting the speed of a wiper based on the judgment in daytime or the night.
      
   3. The rain sensor sends a wiper operation instruction signal to the windshield wiper relay assembly (auto wiper relay) that is based on the amount of rainfall.
      
   4. The wiper speed sensitivity can be adjusted by operating the adjustment ring on the windshield wiper switch assembly.
      
   5. When the windshield wiper relay assembly is in the AUTO position, the rain sensor determines the wiper speed based on vehicle speed received from the combination meter and the amount of raindrops. The rain sensor sends a signal to the windshield wiper relay assembly (auto wiper relay). The windshield wiper relay assembly (auto wiper relay) will vary the wiper speed in accordance with the signal received from the windshield wiper relay assembly (auto wiper relay).
      

Rain Sensor

1. The rain sensor consists of 2 LEDs (Light Emitting Diodes) that emit infrared rays, a photo diode that can receive those rays, a lens, and rain sensor tape.
   

   
   
   
   

   HINT:

   If the windshield glass is being replaced, make sure to affix new rain sensor tape. Failure to do so will lead to a system malfunction.

   1. If no raindrops are present in the detection area, the infrared rays emitted by the LED are all reflected from the outer surface of the windshield glass and are received by the photo diode.
      
   
   
   2. If raindrops are present in the detection area, a portion of the emitted infrared rays penetrates the windshield glass due to the change in the difference of the index of refraction between the glass and the area outside the windshield glass (difference between air and water). The ability of the windshield glass to reflect the emitted rays back inside changes due to the presence of raindrops. This reduces the amount of infrared rays that are received by the photo diode. The amount of this reduction is then used to determine the amount of raindrops. Thus, this function selects the LO, and HI wiper operation in order to operate the wipers at an optimal speed and timing.
      
      
      
      
      
      

General

1. The headlight cleaner system sprays washer fluid on the headlight lenses to clean them.
   

   1. The headlight cleaner control relay controls this system.
      
   2. The headlight cleaner system can be operated by pushing the headlight cleaner switch when the headlights are ON.