Fog Light Assembly Removal
REMOVE COOL AIR INTAKE DUCT SEAL (for 2GR-FE)
REMOVE FRONT BUMPER ASSEMBLY (w/o Headlight Cleaner System)
REMOVE FRONT BUMPER ASSEMBLY (w/ Headlight Cleaner System)
REMOVE FOG LIGHT ASSEMBLY
Fog Light Assembly -- Removal |
1. REMOVE COOL AIR INTAKE DUCT SEAL (for 2GR-FE) |
Remove the 7 clips and cool air intake duct seal.
2. REMOVE FRONT BUMPER ASSEMBLY (w/o Headlight Cleaner System) |
Put protective tape around the front bumper assembly.
Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.
- HINT:
- Use the same procedures for the RH side and LH side.
Remove the 8 screws, 2 clips, 2 radiator grille protectors and bolt.
Disengage the 2 claws and disconnect the front bumper assembly as shown in the illustration.
- HINT:
- Use the same procedures for the RH side and LH side.
Disconnect each connector, and then remove the front bumper assembly.
3. REMOVE FRONT BUMPER ASSEMBLY (w/ Headlight Cleaner System) |
Put protective tape around the front bumper assembly.
Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.
- HINT:
- Use the same procedures for the RH side and LH side.
Remove the 8 screws, 2 clips, 2 radiator grille protectors and bolt.
Disengage the 2 claws and disconnect the front bumper assembly as shown in the illustration.
- HINT:
- Use the same procedures for the RH side and LH side.
Disconnect each connector.
Disconnect the headlight cleaner washer hose, and then remove the front bumper assembly.
4. REMOVE FOG LIGHT ASSEMBLY |
Remove the screw and the fog light assembly.