Front Seat Outer Belt Assembly -- Removal |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait for 90 seconds after disconnecting the cable to prevent airbag deployment (CAMRY_ACV40 RM000000KT107KX.html).
- NOTICE:
- After the ignition switch is turned off, the navigation receiver assembly (HDD navigation system) records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal.
| 2. REMOVE LAP BELT OUTER ANCHOR COVER |
Disengage the 3 claws and remove the lap belt outer anchor cover.
 |
| 3. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY |
Remove the bolt and disconnect the floor end of the front seat outer belt assembly.
 |
| 4. REMOVE FRONT DOOR SCUFF PLATE |
Disengage the 7 claws and 3 clips, and remove the front door scuff plate LH.
 |
| 5. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP |
| 6. REMOVE REAR DOOR SCUFF PLATE |
Disengage the 5 claws and 2 clips, and remove the rear door scuff plate LH.
 |
| 7. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP |
| 8. REMOVE LOWER CENTER PILLAR GARNISH |
Disengage the 2 claws and 2 clips, and remove the lower center pillar garnish LH.
 |
| 9. REMOVE UPPER CENTER PILLAR GARNISH |
Remove the bolt.
 |
Disengage the clip and remove the upper center pillar garnish LH.
| 10. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY |
Remove the nut and disconnect the shoulder anchor of the front seat outer belt assembly.
 |
| 11. REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY |
Remove the 2 bolts and the front shoulder belt anchor adjuster assembly.
 |
| 12. REMOVE FRONT SEAT OUTER BELT ASSEMBLY |
Using a screwdriver, pull out the locking button in the direction shown by the arrow to release the lock, and disconnect the connector as shown in the illustration.
- HINT:
- Tape the screwdriver tip before use.
 |
Remove the 2 bolts and the front seat outer belt assembly.
 |