Skid Control Sensor Inspection

Inspect the skid control sensor. If any of the following occurs, replace the skid control sensor with a new one:

1. The surface of the skid control sensor is cracked, dented, or chipped off.
   
2. The connector is scratched, cracked, or damaged.
   
3. The skid control sensor has been dropped.
   

Measure the resistance according to the value(s) in the table below.

Standard resistance:

LH:

Tester Connection	Specified Condition
1 (RL+) - 2 (RL-)	Below 2.2 kΩ
1 (RL+) - Body ground	10 kΩ or higher
2 (RL-) - Body ground	10 kΩ or higher

RH:

Tester Connection	Specified Condition
1 (RR+) - 2 (RR-)	Below 2.2 kΩ
1 (RR+) - Body ground	10 kΩ or higher
2 (RR-) - Body ground	10 kΩ or higher

Inspect the skid control sensor. If any of the following occurs, replace the skid control sensor with a new one:

1. The surface of the skid control sensor is cracked, dented, or chipped off.
   
2. The connector is scratched, cracked, or damaged.
   
3. The skid control sensor has been dropped.
   

Measure the resistance according to the value(s) in the table below.

Standard resistance:

RH:

Tester Connection	Condition	Specified Condition
2 (RR+) - 1 (RR-)	Always	0.9 to 2.1 kΩ
2 (RR+) - Body ground	Always	10 kΩ or higher
1 (RR-) - Body ground	Always	10 kΩ or higher

LH:

Tester Connection	Condition	Specified Condition
2 (RL+) - 1 (RL-)	Always	0.9 to 2.1 kΩ
2 (RL+) - Body ground	Always	10 kΩ or higher
1 (RL-) - Body ground	Always	10 kΩ or higher