Dtc C0226/21 Sfr Solenoid Circuit

Brake. Camry. Acv40 Gsv40
Brake Control. Camry. Acv40 Gsv40

DESCRIPTION

WIRING DIAGRAM

INSPECTION PROCEDURE

RECONFIRM DTC

DTC C0226/21 SFR Solenoid Circuit

DTC C0236/22 SFL Solenoid Circuit

DTC C0246/23 SRR Solenoid Circuit

DTC C0256/24 SRL Solenoid Circuit


DESCRIPTION

These solenoids turn on when signals are received from the ECU and they control the pressure acting on the wheel cylinders thus controlling braking force.

DTC No.
DTC Detecting Condition
Trouble Area
C0226/21
C0236/22
C0246/23
C0256/24
Solenoid valve signal does not match the check result.
  1. Each solenoid circuit
  2. Brake actuator assembly

WIRING DIAGRAM


Camry. Acv40 Gsv40.Brake Control.Anti-Lock Brake System. Dtc C0226/21 Sfr Solenoid Circuit


INSPECTION PROCEDURE

1.RECONFIRM DTC
HINT:
These codes are detected when a problem is identified in the brake actuator assembly.
The solenoid circuit is in the brake actuator assembly.
Therefore, solenoid circuit inspection and solenoid unit inspection cannot be performed. Be sure to check if the DTC is output before replacing the brake actuator assembly.

  1. Clear the DTC (CAMRY_ACV40 RM000001JB800HX.html).

  1. Start the engine.

  1. Drive the vehicle at a speed of 20 km/h (12 mph) or more for 30 seconds or more.

  1. Check if the same DTC is recorded (CAMRY_ACV40 RM000001JB800HX.html).

    Result:

    Condition
    		Proceed to
    DTC is not output
    		A
    DTC is output
    		B
    HINT:
    1. If the normal system code is output (the trouble code is not output), slightly jiggle the connectors, wire harness, and fuses of the brake actuator assembly. Make sure that no DTCs are output.
    2. If any DTCs are output while jiggling a connector or wire harness of the brake actuator (skid control ECU), inspect and repair the connector or wire harness.
    3. It is suspected that the DTCs were output due to a bad connection of the connector terminal.


B
REPAIR BRAKE ACTUATOR ASSEMBLY (CAMRY_ACV40 RM0000013P6007X.html)
A

END