Rear No. 2 Suspension Arm Installation

Install the rear No. 2 suspension arm (inner side) with the bolt, and temporarily tighten the bolt.

HINT:

Ensure that the paint mark faces to the rear of the vehicle.

Connect the rear No. 2 suspension arm (outer side) to the rear axle carrier with the bolt and nut, and temporarily tighten the bolt.

NOTICE:

When temporarily tightening the bolt, keep the nut from rotating.

Jack up the rear axle carrier, placing a wooden block to avoid damage. Apply load to the suspension so that the installed bolt of the rear suspension No. 1 arm (inner side of vehicle) is horizontally aligned with the center of the rear axle hub.

Fully tighten the bolt.

Torque:

100 N*m{1,020 kgf*cm, 74 ft.*lbf}

Fully tighten the bolt.

Torque:

100 N*m{1,020 kgf*cm, 74 ft.*lbf}

Install the rear height control sensor sub-assembly RH with the nut.

Torque:

5.4 N*m{55 kgf*cm, 48 in.*lbf}