Transmission. Camry. Acv40 Gsv40
E351 Manual Transaxle. Camry. Acv40 Gsv40
Differential Oil Seal -- Installation |
| 1. INSTALL FRONT TRANSAXLE CASE COVER OIL SEAL |
Coat a new oil seal lip with MP grease.
 |
Using SST and a hammer, install the oil seal.
- SST
- 09608-10010
09950-70010(09951-07200)
- Installation depth:
- -0.5 to 0.5 mm (-0.020 to 0.020 in.)
- NOTICE:
- Be careful not to damage the oil seal lip.
| 2. INSTALL TRANSAXLE CASE OIL SEAL |
Coat a new oil seal lip with MP grease.
 |
Using SST and a hammer, install the oil seal.
- SST
- 09608-32010
09950-70010(09951-07200)
- Installation depth:
- 3.0 to 4.0 mm (0.1181 to 0.1575 in.)
- NOTICE:
- Be careful not to damage the oil seal lip.
| 3. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH |
| 4. INSTALL FRONT DRIVE SHAFT ASSEMBLY RH |
- HINT:
- Use the same procedures described for the LH side.
| 5. INSTALL FRONT WHEELS |
- Torque:
- 103 N*m{1,050 kgf*cm, 76 ft.*lbf}
| 6. ADD MANUAL TRANSAXLE OIL |
Park the vehicle on a level place.
 |
Remove the filler plug and gasket.
Check that the oil surface is within 5 mm (0.20 in.) below the lowest point of the filler plug opening.
- Oil grade:
- API GL-4 or GL-5
- Viscosity:
- SAE 75W-90
- NOTICE:
- Problems may occur if the oil level is too high or too low.
- After replacing the oil, drive the vehicle and check the oil level again.
Check for oil leakage if the oil level is low.
Install the filler plug and a new gasket.
- Torque:
- 49 N*m{500 kgf*cm, 36 ft.*lbf}
| 7. INSPECT MANUAL TRANSAXLE OIL |
| 8. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT |
| 9. CHECK ABS SPEED SENSOR SIGNAL |
VSC: (CAMRY_ACV40 RM000000XHT06DX.html).