Clutch Accumulator Installation

Install the clutch accumulator assembly with the 2 nuts.

Torque:

12 N*m{120 kgf*cm, 9 ft.*lbf}

Using SST, connect the clutch lines to the clutch accumulator assembly.

SST

09023-00101

Torque:

15 N*m{155 kgf*cm, 11 ft.*lbf}

Install the release cylinder heat insulator with the 2 bolts.

Torque:

12 N*m{120 kgf*cm, 9 ft.*lbf}

Install the clutch accumulator bracket with the 2 bolts.

Torque:

Bolt A:

12 N*m{120 kgf*cm, 9 ft.*lbf}

Bolt B:

37 N*m{380 kgf*cm, 28 ft.*lbf}

Fill the brake reservoir with brake fluid and bleed the clutch system.

Torque:

8.4 N*m{86 kgf*cm, 74 in.*lbf}

Install the air cleaner case with the 3 bolts.

Torque:

5.0 N*m{51 kgf*cm, 44 in.*lbf}

Connect the hose clamp.

Install the air cleaner filter element onto the air cleaner case.

Insert the hinges. Install the air cleaner cap sub-assembly with the 2 bolts.

Align the matchmarks of the No. 1 air cleaner hose and throttle body, and then connect the air cleaner hose No. 1 to the throttle body and unfasten the No. 1 air cleaner hose clamp.

NOTICE:

Make sure that the hose clamp is at the correct angle.

Connect the No. 2 ventilation hose to the air cleaner hose.

Connect the purge line hose to the clamp (^*1).

Connect the 2 purge VSV vacuum hoses (^*2).

Connect the purge VSV connector (^*3).

Connect the mass air flow meter connector (^*4).

Install the air cleaner inlet with the 2 bolts.

Torque:

5.0 N*m{51 kgf*cm, 44 in.*lbf}

Check the fluid level.
If brake fluid level is lowered, check for leakage and inspect the disc brake pad. If necessary, refill the reservoir with brake fluid after repair and replacement.

Fluid:

SAE J1703 or FMVSS No. 116 DOT 3