Rear View Monitor System (W/O Navigation System) Back Door Courtesy Switch Circuit
DESCRIPTION
WIRING DIAGRAM
INSPECTION PROCEDURE
INSPECT BACK DOOR COURTESY LIGHT SWITCH
CHECK HARNESS AND CONNECTOR (INNER REAR VIEW MIRROR ASSEMBLY - BACK DOOR COURTESY LIGHT SWITCH)
REAR VIEW MONITOR SYSTEM (w/o Navigation System) - Back Door Courtesy Switch Circuit |
DESCRIPTION
The inner rear view mirror assembly receives a back door condition signal from the back door courtesy light switch.
WIRING DIAGRAM
INSPECTION PROCEDURE
| 1.INSPECT BACK DOOR COURTESY LIGHT SWITCH |
Remove the back door courtesy light switch (RAV4_ACA30 RM000001MVH00CX.html).
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
| Condition
| Specified Condition
|
K18-1 - Body ground
| Not pushed (On)
| Below 1 Ω
|
K18-1 - Body ground
| Pushed (Off)
| 10 kΩ or higher
|
| 2.CHECK HARNESS AND CONNECTOR (INNER REAR VIEW MIRROR ASSEMBLY - BACK DOOR COURTESY LIGHT SWITCH) |
Disconnect the R11 inner rear view mirror assembly connector.
Disconnect the K18 back door courtesy light switch connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
| Condition
| Specified Condition
|
R11-10 (BCTY) - K18-1
| Always
| Below 1 Ω
|
R11-10 (BCTY) - Body ground
| Always
| 10 kΩ higher
|
| | REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
