Meter / Gauge System Entire Combination Meter Does Not Operate

DESCRIPTION

WIRING DIAGRAM

INSPECTION PROCEDURE

INSPECT FUSE (GAUGE2, ECU-B, IG2)

INSPECT IG2 RELAY

CHECK WIRE HARNESS (COMBINATION METER - BATTERY AND BODY GROUND)

DESCRIPTION

WIRING DIAGRAM

INSPECTION PROCEDURE

1. Remove the GAUGE2 fuse from the instrument panel junction block.
   

2. Remove the ECU-B fuse from the No. 2 relay block.
   

3. Remove the IG2 fuse from the No. 1 relay block.
   

4. Measure the resistance of the fuses.
   

   Standard resistance:

   Below 1 Ω
   

1. Remove the IG2 relay from the No. 1 relay block.
   

2. Measure the resistance of the relay.
   

   Standard resistance:

   Tester Connection	Specified Condition
   3 - 5	10 kΩ or higher
   3 - 5	Below 1 Ω (when battery voltage is applied to terminals 1 and 2)

1. Disconnect the E22 meter connector.
   

2. Measure the voltage of the wire harness side connector.
   

   Standard voltage:

   Tester Connection	Switch Condition	Specified Condition
   E22-22 (B) - Body ground	Always	11 to 14 V
   E22-21 (IG+) - Body ground	Ignition switch on (IG)	11 to 14 V

3. Measure the resistance of the wire harness side connector.
   

   Standard resistance:

   Tester Connection	Specified Condition
   E22-33 (ET) - Body ground	Below 1 Ω