Wiper And Washer System (W/ Rain Sensor) Power Source Circuit
DESCRIPTION
WIRING DIAGRAM
INSPECTION PROCEDURE
INSPECT FUSE (WIP)
INSPECT IG1 RELAY
CHECK WIRE HARNESS (RELAY - BATTERY AND BODY GROUND)
WIPER AND WASHER SYSTEM (w/ Rain Sensor) - Power Source Circuit |
DESCRIPTION
This circuit provides power to the auto wiper relay.
WIRING DIAGRAM
INSPECTION PROCEDURE
Remove the WIP fuse from the instrument panel junction block.
Measure the resistance of the fuse.
- Standard resistance:
- Below 1 Ω
Remove the IG1 relay from the instrument panel junction block.
Measure the resistance of the relay.
- Standard resistance:
Tester Connection
| Specified Condition
|
3 - 5
| 10 kΩ or higher
|
Below 1 Ω
(when battery voltage is applied to terminals 1 and 2)
|
| 3.CHECK WIRE HARNESS (RELAY - BATTERY AND BODY GROUND) |
Disconnect the E66 relay connector.
Measure the voltage of the wire harness side connector.
- Standard voltage:
Tester Connection
| Switch Condition
| Specified Condition
|
E66-12 (IG) - Body ground
| Ignition switch on (IG)
| 10 to 14 V
|
Measure the resistance of the wire harness side connector.
- Standard resistance:
Tester Connection
| Specified Condition
|
E66-26 (E) - Body ground
| Below 1 Ω
|
| | REPAIR OR REPLACE HARNESS AND CONNECTOR |
|
|
| OK |
|
|
|
| PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE |
|
