Luggage Room Light Removal
Lighting. Toyota Rav4. Aca30, 33, 38 Gsa33 Zsa30, 35
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
REMOVE BACK DOOR CENTER GARNISH
REMOVE BACK DOOR SIDE GARNISH LH
REMOVE BACK DOOR SIDE GARNISH RH
REMOVE BACK DOOR TRIM BOARD
REMOVE BACK DOOR COURTESY LIGHT ASSEMBLY
Luggage Room Light -- Removal |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
- NOTICE:
- w/ Navigation System for HDD:
- After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.
| 2. REMOVE BACK DOOR CENTER GARNISH |
Using a screwdriver, detach the 4 claws and 4 clips and remove the garnish.
- HINT:
- Tape the screwdriver tip before use.
| 3. REMOVE BACK DOOR SIDE GARNISH LH |
Using a screwdriver, detach the 2 claws and 2 clips and remove the garnish.
| 4. REMOVE BACK DOOR SIDE GARNISH RH |
- HINT:
- Use the same procedure described for the LH side.
| 5. REMOVE BACK DOOR TRIM BOARD |
Using a screwdriver, detach the 13 clips and remove the trim board.
- HINT:
- Tape the screwdriver tip before use.
- If the screwdriver cannot reach the clips, pull on the lower trim to remove it.
Remove the 5 screws and the back door trim pocket.
| 6. REMOVE BACK DOOR COURTESY LIGHT ASSEMBLY |
Using a screwdriver, pry out the light as shown in the illustration.
- HINT:
- Tape the screwdriver tip before use.
Detach the 4 claws and remove the light shade.
Remove the light bulb from the light.
