Securities. Toyota Rav4. Aca30, 33, 38 Gsa33 Zsa30, 35
Engine Immobiliser. Toyota Rav4. Aca30, 33, 38 Gsa33 Zsa30, 35
Engine Immobiliser System (W/O Entry And Start System) -- Data List / Active Test |
| READ DATA LIST |
- HINT:
- Using the intelligent tester's Data List allows switch, sensor, actuator and other item values to be read without removing any parts. Reading the Data List early in troubleshooting is one way to save time.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON and turn the tester ON.
Select the following menu items: Body / Immobiliser / Data List.
Check the results by referring to the table below.
Immobiliser Tester Display Measurement Item/Range Normal Condition Diagnostic Note IG SW Ignition switch signal / ON or OFF ON: Ignition switch ON or ACC
OFF: Ignition switch off- Key SW Unlock warning switch signal / ON or OFF ON: Key is in ignition key cylinder
OFF: No key is in ignition key cylinder- +B +B judgment / Normal or Break Normal: Battery supply is normal
Break: Battery supply is malfunctioning- Antenna Coil Status Transponder key coil condition / Normal or Fail Normal: Transponder key coil is normal
Fail: Transponder key coil is malfunctioning- Permit (Start) Engine starting control / OK or NG OK: Engine start is permitted
NG: Engine start is not permitted- Immobiliser Immobiliser system status / Set or Unset Unset: Key is in ignition key cylinder
Set: No key is in ignition key cylinder- Master Key Master key code signal / Unreg or Reg Unreg: Unmatched master key code is sent
Reg: Registered master key code is sent- Sub Key Sub-key code signal / Unreg or Reg Unreg: Unmatched sub-key code is sent
Reg: Registered sub-key code is sent- BCC Malfunction Transponder chip signal / NG or OK NG: Incorrect data sent
OK: Correct data sent- Abnormal Function Transponder chip data / NG or OK NG: Data error
OK: Data OK- Different Encrypt Code Transponder chip data / NG or OK NG: Data error
OK: Data OK- Different Serial Number Transponder chip data / NG or OK NG: Data error
OK: Data OK- Frame Error Transponder chip data / NG or OK NG: Data error
OK: Data OK- Response Transponder chip data / NG or OK NG: Data error
OK: Data OK- Reg Code Space Full Key registration code memory space full / No or Yes No: Possible to register more key codes
Yes: Cannot register any more key codes- Transponda M-Code Number of registered master keys / min.: 0, max.: 15 Number of registered master keys - Transponda S-Code Number of registered sub-keys / min.: 0, max.: 15 Number of registered sub-keys -
| PERFORM ACTIVE TEST |
- HINT:
- Performing the intelligent tester's Active Test allows relay, VSV, actuator and other items to be operated without removing any parts. Performing the Active Test early in troubleshooting is one way to save time. The Data List can be displayed during the Active Test.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON and turn the tester ON.
Select the following menu items: Body / Immobiliser / Active Test.
Perform the Active Test by referring to the table below.
Immobiliser Tester Display Test Part Control Range Diagnostic Note Security Indic Turn security indicator light ON or OFF -