Dtc B2762 Intrusion Sensor Signal Circuit Malfunction
Securities. Toyota Rav4. Aca30, 33, 38 Gsa33 Zsa30, 35
DESCRIPTION
WIRING DIAGRAM
INSPECTION PROCEDURE
CHECK WIRE HARNESS (OVERHEAD JUNCTION BLOCK - THEFT WARNING ECU AND BODY GROUND)
CHECK OVERHEAD JUNCTION BLOCK (OPERATION)
DTC B2762 Intrusion Sensor Signal Circuit Malfunction |
DESCRIPTION
The intrusion sensor (built into the overhead junction block) conducts self-diagnosis immediately after power is supplied to the sensor (when the theft deterrent system is set).If a malfunction is detected in the IOUT - IOUT line, the theft warning ECU outputs this DTC.DTC No.
| DTC Detection Condition
| Trouble Area
|
B2762
| After normal / trouble signal is output from intrusion sensor as result of self-diagnosis, following malfunctions are detected:
- Intrusion communication line is open
- Reception of signals other than normal / trouble signals
| - Wire harness
- Overhead junction block (intrusion sensor)
- Theft warning ECU
|
WIRING DIAGRAM
INSPECTION PROCEDURE
| 1.CHECK WIRE HARNESS (OVERHEAD JUNCTION BLOCK - THEFT WARNING ECU AND BODY GROUND) |
Disconnect the R8 junction block connector.
Disconnect the E83 ECU connector.
Measure the resistance of the wire harness side connectors.
- Standard resistance:
Tester Connection
| Specified Condition
|
R8-4 (IOUT) - E83-8 (IOUT)
| Below 1 Ω
|
R8-7 (GND) - Body ground
|
R8-4 (IOUT) or E83-8 (IOUT) - Body ground
| 10 kΩ or higher
|
| | REPAIR OR REPLACE HARNESS AND CONNECTOR |
|
|
| 2.CHECK OVERHEAD JUNCTION BLOCK (OPERATION) |
Temporarily replace the overhead junction block (intrusion sensor) with a new or normally functioning one (RAV4_ACA30 RM000001GED00BX.html).
Check for a DTC.
- OK:
- DTC B2762 is not output.
| | REPLACE THEFT WARNING ECU |
|
|
| OK |
|
|
|
| END (INTRUSION SENSOR IS DEFECTIVE) |
|
