Side Airbag Sensor Removal
Restraints. Toyota Rav4. Aca30, 33, 38 Gsa33 Zsa30, 35
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
REMOVE FRONT DOOR SCUFF PLATE LH
REMOVE REAR DOOR SCUFF PLATE LH (for Short Body)
REMOVE REAR DOOR SCUFF PLATE LH (for Long Body)
REMOVE CENTER PILLAR GARNISH LOWER LH
REMOVE SIDE AIRBAG SENSOR ASSEMBLY LH
Side Airbag Sensor -- Removal |
- CAUTION:
- Be sure to read the precautionary notices concerning the SRS airbag system before servicing it (RAV4_ACA30 RM000000KT106QX.html).
- HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
- NOTICE:
- w/ Navigation System for HDD:
- After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.
2. REMOVE FRONT DOOR SCUFF PLATE LH |
Using a screwdriver, detach the 10 claws and remove the scuff plate.
- HINT:
- Tape the screwdriver tip before use.
3. REMOVE REAR DOOR SCUFF PLATE LH (for Short Body) |
Using a screwdriver, detach the 8 claws and remove the scuff plate.
- HINT:
- Tape the screwdriver tip before use.
4. REMOVE REAR DOOR SCUFF PLATE LH (for Long Body) |
Using a screwdriver, detach the 9 claws.
- HINT:
- Tape the screwdriver tip before use.
Using a clip remover, detach the 2 clips and remove the garnish.
5. REMOVE CENTER PILLAR GARNISH LOWER LH |
Remove the lap belt outer anchor cover.
Remove the anchor's built-in bolt from the pillar and disconnect the outer belt.
Using a screwdriver, detach the 2 claws.
- HINT:
- Tape the screwdriver tip before use.
Using a clip remover, detach the 2 clips and remove the garnish.
6. REMOVE SIDE AIRBAG SENSOR ASSEMBLY LH |
Disconnect the connector.
Remove the bolt and sensor.