Restraints. Toyota Rav4. Aca30, 33, 38 Gsa33 Zsa30, 35
Supplemental Restraint System. Toyota Rav4. Aca30, 33, 38 Gsa33 Zsa30, 35
Curtain Shield Airbag Assembly -- Removal |
- HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.
- CAUTION:
- Be sure to read the precautionary notices concerning the SRS airbag system before servicing it (RAV4_ACA30 RM000000KT106QX.html).
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
- NOTICE:
- w/ Navigation System for HDD:
- After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.
| 2. TEST ROOF HEADLINING ASSEMBLY |
Short body:
Remove the roof headlining (RAV4_ACA30 RM000001XUT002X_01_0040.html).
Long body:
Remove the roof headlining (RAV4_ACA30 RM000001XUZ002X_01_0044.html).
| 3. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY LH |
Disconnect the connector.
- NOTICE:
- When handling the airbag connector, take care not to damage the airbag wire harness.
Shot body:
Remove the 9 bolts and curtain shield airbag.
Long body:
Remove the 10 bolts and curtain shield airbag.
| 4. REMOVE ROOF SIDE RAIL BRACKET LH |
Remove the 2 bolt and bracket.
 |