Skid Control Sensor (For 2Wd) Installation

Install the rear axle hub and bearing LH (RAV4_ACA30 RM00000227Q006X.html).

Align the matchmarks and install the disc.

HINT:

When replacing the disc with a new one, select the installation position where the disc has the smallest runout.

Install the cylinder mounting with the 2 bolts.

Torque:

88 N*m{897 kgf*cm, 65 ft.*lbf}

Connect the skid control sensor wire connector (labeled A) to the skid control sensor.

Install the sensor clamp (labeled B) with the bolt (labeled C).

Torque:

8.5 N*m{87 kgf*cm, 75 in.*lbf}

NOTICE:

Do not twist the sensor wire when installing the clamp.

Install the sensor clamps (labeled D) with the 2 nuts (labeled E).

Torque:

5.0 N*m{51 kgf*cm, 44 in.*lbf}

NOTICE:

Do not twist the sensor wire when installing the clamps.

Install the sensor clamp (labeled F) with the bolt (labeled G).

Torque:

8.5 N*m{87 kgf*cm, 75 in.*lbf}

NOTICE:

Do not twist the sensor wire when installing the clamp.

Insert the connector and grommet into the inside of the vehicle through the passage hole in the wheel house.

NOTICE:

Make sure the grommet band clamp remains on the outside of the vehicle.

Hold the grommet and pull it toward the outside of the vehicle. Then fix the grommet in place so that it is not tilted.

NOTICE:

1. When pulling out the grommet, do not grip the sensor wire.
   
2. Fix the grommet in place within the range shown in the illustration.
   

Connect the skid control sensor wire connector.

Install the deck trim side panel LH (RAV4_ACA30 RM000001XUX003X.html).

HINT:

Refer to the procedures from the installation of the deck trim side panel LH up until the installation of the rear door scuff plate LH.

w/o VSC:
Check the speed sensor signal (RAV4_ACA30 RM000000ONN01NX.html).

w/ VSC:
Check the speed sensor signal (RAV4_ACA30 RM0000022CZ007X.html).