Underdrive Clutch Disassembly

Install the underdrive clutch to the transaxle case.

NOTICE:

Be careful not to damage the oil seal rings.

Install a dial indicator as shown in the illustration.

Measure the underdrive clutch pack clearance while applying and releasing compressed air (392 kPa, 4.0 kgf/cm², 57 psi).

Standard pack clearance:

1.51 to 1.90 mm (0.0594 to 0.0748 in.)

Using a screwdriver, pry out the snap ring.

Remove the flange, 3 discs and 3 plates from the underdrive clutch drum.

Check to see if the sliding surface of the disc, plate and flange are worn or burnt. If necessary, replace them.

HINT:

1. If the lining of the disc is peeling off or discolored, or even if a part of the printed mark is defaced, replace all discs.
   
2. Before assembling new discs, soak them in ATF for at least 15 minutes.
   

Place SST on the clutch balancer and compress the spring with a press.

SST

09350-32014(09351-32070)

Using a snap ring expander, remove the snap ring.

NOTICE:

1. Stop the press when the spring sheet is lowered to the place 1 to 2 mm (0.039 to 0.078 in.) from the snap ring groove.
   
2. This prevents the spring sheet from being deformed.
   
3. Do not expand the snap ring excessively.
   

Remove the clutch balancer and piston return spring from the underdrive clutch drum.

Install the underdrive clutch to the transaxle case.

NOTICE:

Be careful not to damage the oil seal rings.

Holding the underdrive clutch piston with your hand, apply compressed air (392 kPa, 4.0 kgf/cm², 57 psi) to the transaxle case to remove the underdrive clutch piston.

Using a vernier caliper, measure the free length of the spring together with the spring seat.

Standard free length:

17.14 mm (0.6748 in.)

Using a caliper gauge, measure the inside diameter of the underdrive clutch drum bush.

Standard drum bush:

32.56 to 32.58 mm (1.2818 to 1.2826 in.)

Maximum drum bush:

32.63 mm (1.2846 in.)