Dtc B2272 Ignition 1 Monitor Malfunction

Engine. Toyota Rav4. Aca30, 33, 38 Gsa33 Zsa30, 35
3Zr-Fae Starting. Toyota Rav4. Aca30, 33, 38 Gsa33 Zsa30, 35

DESCRIPTION

WIRING DIAGRAM

INSPECTION PROCEDURE

READ VALUE USING INTELLIGENT TESTER (IG1 RELAY MONITOR [INSIDE])

CHECK SWITCH CONDITION (ENGINE SWITCH)

INSPECT IG1 RELAY

DTC B2272 Ignition 1 Monitor Malfunction


DESCRIPTION

This DTC is stored when a malfunction occurs in the IG output circuit, which is between the IG1 relay actuation circuit inside the main body ECU and the IG1 relay.

DTC Code
DTC Detection Condition
Trouble Area
B2272
IG1 relay actuation circuit inside the main body ECU or other related circuit is malfunctioning.
  1. Main body ECU
  2. IG1 relay
  3. Harness or connector

WIRING DIAGRAM


Toyota Rav4. Aca30, 33, 38 Gsa33 Zsa30, 35.3Zr-Fae Starting.Starting System (W/ Entry And Start System). Dtc B2272 Ignition 1 Monitor Malfunction


INSPECTION PROCEDURE

1.READ VALUE USING INTELLIGENT TESTER (IG1 RELAY MONITOR [INSIDE])

  1. Connect the intelligent tester to the DLC3.

  1. Turn the engine switch on (IG) and turn the intelligent tester on.

  1. Enter the following menus: Body / Main Body / Data List.

  1. Read the display on the intelligent tester.

    Main Body
    Tester Display
    		Measurement Item/Range
    		Normal Condition
    		Diagnosis Note
    IG1 Relay Monitor(Inside)
    		IG1 inner relay monitor/ON or OFF
    		ON: Engine switch on (IG)
    OFF: Engine switch off
    		-
    OK:
    When the engine switch is turned on (IG), ON is displayed on the intelligent tester.


NG
Go to step 3
OK


2.CHECK SWITCH CONDITION (ENGINE SWITCH)

  1. Make sure that the electrical key is inside the cabin.

  1. With the shift lever in P (except M/T), check that the power source mode changes as shown below each time the engine switch is pushed.

    OK:
    off → on (ACC) → on (IG) → off


NG
GO TO POWER SOURCE MODE DOES NOT CHANGE (RAV4_ACA30 RM000000Y7X01JX.html)
OK

USE SIMULATION METHOD TO CHECK (RAV4_ACA30 RM000000UZ306OX.html)

3.INSPECT IG1 RELAY


    Toyota Rav4. Aca30, 33, 38 Gsa33 Zsa30, 35.3Zr-Fae Starting.Starting System (W/ Entry And Start System). Dtc B2272 Ignition 1 Monitor Malfunction

  1. Remove the IG1 relay from the instrument panel junction block.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    		Condition
    		Specified Condition
    3 - 5
    		Battery voltage is applied to terminals 1 and 2
    		Below 1 Ω
    3 - 5
    		Battery voltage is not applied to terminals 1 and 2
    		10 kΩ or higher


NG
REPLACE IG1 RELAY
OK

REPLACE MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK)