Engine. Toyota Rav4. Aca30, 33, 38 Gsa33 Zsa30, 35
2Gr-Fe Engine Mechanical. Toyota Rav4. Aca30, 33, 38 Gsa33 Zsa30, 35
Drive Belt -- Installation |
| 1. INSTALL V-RIBBED BELT |
Rotate the tensioner pulley counterclockwise, and then install the V-ribbed belt.
 |
If it is difficult to install the V-ribbed belt, perform the following procedure.
Put the V-ribbed belt on everything except the tensioner pulley as shown in the illustration.
While releasing the belt tension by turning the belt tensioner counterclockwise, put the V-ribbed belt on the tensioner pulley.
- NOTICE:
- Put the backside of the V-ribbed belt on the tensioner pulley and idler pulley.
- Check that the V-ribbed belt is properly set to each pulley.
 |
| 2. INSTALL FRONT SUSPENSION MEMBER REINFORCEMENT RH |
Install the reinforcement with the 4 bolts.
- Torque:
- 96 N*m{978 kgf*cm, 71 ft.*lbf}
 |
| 3. INSTALL REAR ENGINE UNDER COVER RH |
Install the under cover with the 2 clips.
| 4. INSTALL NO. 1 ENGINE UNDER COVER |
Install the under cover with the 2 bolts, 4 screw and 12 clips.
| 5. CONNECT RADIATOR RESERVOIR TANK ASSEMBLY |
Connect the reservoir tank with the 2 bolts.
- Torque:
- 5.0 N*m{51 kgf*cm, 44 in.*lbf}
 |
| 6. INSTALL V-BANK COVER SUB-ASSEMBLY |
Attach the 3 clips to install the engine cover.
 |
| 7. INSTALL RADIATOR SUPPORT OPENING COVER |
Install the cover with the 9 clips.
 |