Ignition Relay No. 2 On-Vehicle Inspection

Engine. Toyota Rav4. Aca30, 33, 38 Gsa33 Zsa30, 35
2Az-Fe Engine Control System. Toyota Rav4. Aca30, 33, 38 Gsa33 Zsa30, 35

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

  2. REMOVE IG2 RELAY

  3. INSPECT IG2 RELAY

  4. INSTALL IG2 RELAY

  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Ignition Relay No. 2 -- On-Vehicle Inspection



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


2. REMOVE IG2 RELAY

  1. Remove the No. 1 engine room relay block cover.

  1. Remove the IG2 relay from the engine room relay block.



3. INSPECT IG2 RELAY


    Toyota Rav4. Aca30, 33, 38 Gsa33 Zsa30, 35.2Az-Fe Engine Control System.Sfi System.Ignition Relay No. 2 On-Vehicle Inspection

  1. Measure the resistance of the IG2 relay.

    Standard resistance:
    Tester Connection
    		Specified Condition
    3 - 5
    		10 kΩ or higher
    3 - 5
    		Below 1 Ω
    (when battery voltage is applied to terminals 1 and 2)
    If the result is not as specified, replace the relay.


4. INSTALL IG2 RELAY


5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL