Sfi System Dtc Check / Clear

Engine. Toyota Rav4. Aca30, 33, 38 Gsa33 Zsa30, 35
1Az-Fe Engine Control System. Toyota Rav4. Aca30, 33, 38 Gsa33 Zsa30, 35

  1. CHECK DTC (Using intelligent tester)

  1. CLEAR DTC (Using intelligent tester)

  1. CLEAR DTC (Without using intelligent tester)

Sfi System -- Dtc Check / Clear


NOTICE:
When the diagnosis system is changed from normal mode to check mode or vice versa, all DTCs and freeze frame data that were recorded in normal mode are erased. Before changing modes, always check and make a note of any DTCs and freeze frame data,
HINT:
  1. DTCs which are stored in the ECM can be displayed on the intelligent tester. The intelligent tester can display both current and pending DTCs.
  2. Malfunctions that were not detected a second time by the ECM during the second driving cycle are stored as pending DTCs.

CHECK DTC (Using intelligent tester)
Toyota Rav4. Aca30, 33, 38 Gsa33 Zsa30, 35.1Az-Fe Engine Control System.Sfi System.Sfi System Dtc Check / Clear

  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch on (IG) and turn the tester on.

  3. Select the following menu items: Powertrain / Engine and ECT / DTC.

  4. Check the DTC(s) and freeze frame data, and then write them down.

  5. Check the details of the DTC(s) (RAV4_ACA30 RM000000PDF0FLX.html).


CLEAR DTC (Using intelligent tester)

  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch on (IG) and turn the tester on.

  3. Select the following menu items: Powertrain / Engine and ECT / DTC / Clear.

  4. Press the YES button.


CLEAR DTC (Without using intelligent tester)

  1. Perform either of the following operations.

    1. Disconnect the cable from the negative (-) battery terminal for more than 1 minute.

    2. Remove the EFI MAIN and ETCS fuses from the No. 1 engine room relay block (located inside the engine compartment) for more than 1 minute.