Quarter Window Glass (For 3 Door) Installation

Using a brush or sponge, apply primer M to the exposed part of the vehicle body.

NOTICE:

1. Allow the primer coating to dry for 3 minutes or more.
   
2. Throw away any leftover primer.
   
3. Do not apply too much primer.
   

Using a brush or sponge, apply Primer G to the contact surface of the glass.

Standard:

Area	Specified Condition
a	7.0 mm (0.276 in.)
b	5.5 mm (0.217 in.)
c	6.5 mm (0.256 in.)
d	8.0 mm (0.315 in.)

HINT:

If primer is applied to an area that is not specified, wipe off the primer with non-residue solvent before it dries.

NOTICE:

1. Allow the primer to dry for 3 minutes or more.
   
2. Throw away any leftover primer.
   
3. Do not apply too much primer.
   

Apply adhesive to the quarter window glass.

Adhesive:

Toyota Genuine Windshield Glass Adhesive or equivalent

1. Cut off a tip of the cartridge nozzle as shown in the illustration.
   
   

   
   
   
   
   

   Text in Illustration

   *1	Adhesive	-
   *a	Backside	*b	Adhesive Center Line

   Standard:

   Area	Specified Condition
   a	12.0 mm (0.472 in.)
   b	8.0 mm (0.315 in.)
   c	5.5 mm (0.217 in.)
   d	6.5 mm (0.256 in.)
   e	7.0 mm (0.276 in.)

   HINT:

   After cutting off the tip, use all adhesive within the time written in the table below.

   Usage Time Frame:

   Temperature	Usage Time Frame
   35°C (95°F)	15 minutes
   20°C (68°F)	1 hour 40 minutes
   5°C (41°F)	8 hours

2. Load a sealer gun with the cartridge.
   

3. Apply adhesive to the quarter window glass as shown in the illustration.
   

Install the quarter window glass to the vehicle body.

1. Attach the 4 clips to install the quarter window assembly LH.
   

   NOTICE:

   Allow the primer to dry for 3 minutes or more.

2. Hold the quarter window glass in place securely with protective tape or equivalent until the adhesive hardens.
   

   NOTICE:

   1. Allow the primer coating to dry for 3 minutes or more.
      
   2. Check the clearance between the body and glass.
      

3. Lightly press the front surface of the glass to ensure a close fit.
   





4. Using a scraper, remove any excess or protruding adhesive.
   

   HINT:

   Apply adhesive to any areas where the amount of adhesive is inadequate.

   NOTICE:

   Do not drive the vehicle within the time written in the table below.

   Minimum Time:

   Temperature	Minimum Time Prior to Driving Vehicle
   35°C (95°F)	1 hour 30 minutes
   20°C (68°F)	5 hours
   5°C (41°F)	24 hours

   Text in Illustration

   *1

   Adhesive

Conduct a leak test after the adhesive has completely hardened.

Seal any leaks with auto glass sealer.

Install a new clip A to the roof side rail garnish.

Attach the 5 clips to install the roof side rail garnish.

Install the roof headlining assembly (LandCruiser RM0000046JO00WX.html).