Power Window Regulator Motor (For Front Door) Inspection

Apply positive (+) battery voltage to the connector terminal 2 (B).

NOTICE:

Do not apply positive (+) battery voltage to any terminals except terminal 2 (B) to avoid damaging the pulse sensor inside the motor.

Apply negative (-) battery voltage to the connector terminals 1 (GND) and 7 (DOWN) or 10 (UP).

Check that the motor gear rotates smoothly as follows.

OK:

Measurement Condition	Specified Condition
Connect the positive (+) battery cable to terminal 2 (B), and connect the negative (-) battery cable to terminal 1 (GND), and keep them connected for 3 seconds or more. With terminals 2 (B) and 1 (GND) connected, connect the negative (-) battery cable to terminal 10 (UP). Disconnect and reconnect the negative (-) battery cable to terminal 10 (UP) within 1 second.	Motor gear rotates clockwise (Up)
Connect the positive (+) battery cable to terminal 2 (B), and connect the negative (-) battery cable to terminal 1 (GND), and keep them connected for 3 seconds or more. With terminals 2 (B) and 1 (GND) connected, connect the negative (-) battery cable to terminal 7 (DOWN). Disconnect and reconnect the negative (-) battery cable to terminal 7 (DOWN) within 1 second.	Motor gear rotates counterclockwise (Down)

1. If the result is not as specified, replace the front power window regulator motor assembly LH.
   

CAUTION:

Reset the power window regulator motor (initialize the pulse sensor) after installing the power window regulator motor and regulator assembly onto the door.

Apply positive (+) battery voltage to the connector terminal 2 (B).

NOTICE:

Do not apply positive (+) battery voltage to any terminals except terminal 2 (B) to avoid damaging the pulse sensor inside the motor.

Apply negative (-) battery voltage to the connector terminals 1 (GND) and 7 (DOWN) or 10 (UP).

Check that the motor gear rotates smoothly as follows.

OK:

Measurement Condition	Specified Condition
Connect the positive (+) battery cable to terminal 2 (B), and connect the negative (-) battery cable to terminal 1 (GND), and keep them connected for 3 seconds or more. With terminals 2 (B) and 1 (GND) connected, connect the negative (-) battery cable to terminal 10 (UP). Disconnect and reconnect the negative (-) battery cable to terminal 10 (UP) within 1 second.	Motor gear rotates counterclockwise (Up)
Connect the positive (+) battery cable to terminal 2 (B), and connect the negative (-) battery cable to terminal 1 (GND), and keep them connected for 3 seconds or more. With terminals 2 (B) and 1 (GND) connected, connect the negative (-) battery cable to terminal 7 (DOWN). Disconnect and reconnect the negative (-) battery cable to terminal 7 (DOWN) within 1 second.	Motor gear rotates clockwise (Down)

1. If the result is not as specified, replace the front power window regulator motor assembly RH.
   

CAUTION:

Reset the power window regulator motor (initialize the pulse sensor) after installing the power window regulator motor and regulator assembly onto the door.