Height Control Sensor Removal


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

  2. REMOVE REAR WHEEL

  3. REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH

  4. REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY RH

Height Control Sensor -- Removal


NOTICE:
Before removal, be sure to disable vehicle height control by pressing the height control OFF switch and confirming that the height control OFF indication is displayed on the meter.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
  1. After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (LandCruiser RM000003YMD00TX.html).
  2. When disconnecting the cable, some systems need to be initialized after the cable is reconnected (LandCruiser RM000003YMF011X.html).


2. REMOVE REAR WHEEL


3. REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH


    Land Cruiser, Land Cruiser Prado. Grj150 Trj150,155 Kdj150,155 Lj150, Gdj150,155

  1. Disconnect the connector, and then detach the connector.

  1. Detach the clamp.



    Land Cruiser, Land Cruiser Prado. Grj150 Trj150,155 Kdj150,155 Lj150, Gdj150,155.Suspension Control.Air Suspension System.Height Control Sensor Removal

  1. Place matchmarks on the link and bracket.

    Text in Illustration
    *1
    		Matchmark

  1. Remove the nut and disconnect the sensor link.

  1. Remove the 2 bolts and height control sensor.

    NOTICE:
    Replace the rear height control sensor sub-assembly with a new one if it is dropped.


4. REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY RH
HINT:
Use the same procedure described for the LH side.