Suspension Control System (W/ Kdss) -- On-Vehicle Inspection |
| 1. INSPECT VEHICLE HEIGHT |
- NOTICE:
- Perform the inspection on a level surface.
- Make sure that the wheels are on the ground and facing straight ahead.
- Perform the inspection with the vehicle load completely on the suspension.
- HINT:
- Perform this step with the fuel tank full.
- If there are any parts installed to the vehicle which place any unbalanced load on the left or right side of the vehicle, remove them.
Set the tire pressure to the specified value(s) (LandCruiser RM000003DGS00UX_01_0001.html).
Bounce the vehicle to stabilize the suspension.
Measure the distance from the ground to the top of the bumper and calculate the difference in the vehicle height between the left and right sides. Perform this procedure for both the front and rear wheels.
- Height difference of left and right sides:
- 20 mm (0.787 in.) or less
- HINT:
- When the difference in vehicle height between the left and right sides is outside of the specification, perform air bleeding (LandCruiser RM0000038U7010X.html).
 |
| 2. INSPECT FOR SUSPENSION FLUID LEAK |
- CAUTION:
- Fluid is pumped into the system at a high pressure of approximately 3 MPa (30.6 kgf/cm2, 435 psi). If a fluid leak is discovered, immediately release the pressure and repair the fluid leak.
Perform a driving test.
Check for fluid leakage from the parts and connections shown in the illustration.
