Front Propeller Shaft Assembly Disassembly

Place matchmarks on the flange yoke and sleeve yoke.

Using a brass bar and hammer, slightly tap in the spider bearing outer races.

Using 2 screwdrivers, remove the 4 snap rings from the grooves.

Using SST, remove the spider bearing from the propeller shaft.

SST

09332-25010

HINT:

Before installing SST, sufficiently raise the part labeled A. If the part labeled A is too low, it may be difficult to install SST.

Clamp the spider bearing outer race in a vise between aluminum plates and tap off the propeller shaft with a hammer.

HINT:

Remove the bearing on the opposite side using the same procedure.

NOTICE:

Do not tap the shaft.

Install the 2 removed spider bearing outer races to the universal joint spider.

Using SST, remove the bearing from the yoke.

SST

09332-25010

HINT:

Before installing SST, sufficiently raise the part labeled A. If the part labeled A is too low, it may be difficult to install SST.

Clamp the outer bearing race in a vise between aluminum plates and tap off the flange yoke with a hammer.

Remove the universal joint spider.