Oil Pressure Switch Installation

Apply adhesive to 2 or 3 threads of the engine oil pressure switch assembly.

Adhesive:

TOYOTA Genuine Adhesive 1344, Three Bond 1344 or equivalent

NOTICE:

Do not let adhesive adhere to the oil hole.

Using a 24 mm deep socket wrench, install the engine oil pressure switch assembly.

Torque:

15 N*m{153 kgf*cm, 11 ft.*lbf}

NOTICE:

Do not start the engine within 1 hour of installation.

Connect the engine oil pressure switch assembly connector.

Start the engine. Make sure that there are no oil leaks from the areas that were worked on.

Warm up the engine, stop the engine and wait 5 minutes.

Check that the oil level is between the dipstick low level mark and full level mark.
If the level is low, check for leakage and add oil up to the full level mark.

NOTICE:

Do not fill engine oil above the full level mark.

Hook the No. 1 engine under cover sub-assembly to the vehicle body as shown in the illustration.

Install the 4 bolts.

Torque:

29 N*m{296 kgf*cm, 21 ft.*lbf}

Install the front bumper cover lower with the 5 bolts and clip.

Torque:

8.0 N*m{82 kgf*cm, 71 in.*lbf}