Oil Pressure Switch -- Installation |
| 1. INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY |
Apply adhesive to 2 or 3 threads of the engine oil pressure switch assembly.
Text in Illustration *a Adhesive - Adhesive:
- Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent
- NOTICE:
- Do not apply adhesive to the oil inlet port of the engine oil pressure switch assembly.
 |
Using a 24 mm deep socket wrench, install the engine oil pressure switch assembly to the oil filter bracket.
- Torque:
- 15 N*m{153 kgf*cm, 11 ft.*lbf}
- NOTICE:
- Do not start the engine for at least 1 hour after the installation.
Attach the 2 clamps to connect the wire harness.
Connect the 2 connectors.
| 2. ADD ENGINE OIL |
Add new engine oil and install the oil filler cap assembly.
- Oil Grade:
Oil Grade Oil Viscosity (SAE) ACEA C2
(Using engine oil other than ACEA C2 may damage the catalytic converter)- 0W-30
- 5W-30
- Standard Capacity:
Item Specified Condition Drain and refill without oil filter sub-assembly change 7.0 liters (7.4 US qts, 6.2 Imp. qts) Drain and refill with oil filter sub-assembly change 7.5 liters (7.9 US qts, 6.6 Imp. qts) Dry fill 8.0 liters (8.5 US qts, 7.0 Imp. qts)
| 3. INSPECT FOR OIL LEAK |
Start the engine. Make sure that there are no oil leaks from the areas that were worked on.
| 4. INSTALL REAR ENGINE UNDER COVER ASSEMBLY |
Install the rear engine under cover with the 4 bolts.
- Torque:
- 29 N*m{296 kgf*cm, 21 ft.*lbf}