Front Crankshaft Oil Seal Installation

Apply MP grease to the lip of a new timing chain case oil seal.

NOTICE:

1. Do not allow foreign matter to contact the lip of the timing chain case oil seal.
   
2. Do not allow MP grease to contact the dust seal.
   

Temporarily install the timing chain case oil seal to the timing chain cover sub-assembly.

Using SST and a hammer, tap in the timing chain case oil seal until its surface is flush with the chain cover edge.

SST

09223-75010
09950-70010(09951-07100)

NOTICE:

1. Keep the lip free from foreign matter.
   
2. Do not tap the timing chain case oil seal at an angle.
   

Align the key groove of the crankshaft pulley with the pulley set key and slide on the crankshaft pulley.

Using SST, install a new crankshaft pulley bolt.

SST

09213-54015(91651-60855)
09330-00021

Torque:

260 N*m{2651 kgf*cm, 192 ft.*lbf}

Text in Illustration

*a	Hold
	Turn

NOTICE:

Do not reuse the pulley bolt.

Install the fan pulley to the engine water pump assembly.

Place the shroud together with the coupling fan between the radiator assembly and engine.

NOTICE:

Be careful not to damage the radiator core.

Temporarily install the fluid coupling fan to the engine water pump assembly with the 4 nuts. Tighten the nuts as much as possible by hand.

Attach the claws of the shroud to the radiator assembly as shown in the illustration.

Install the fan shroud with the 2 bolts.

Torque:

5.0 N*m{51 kgf*cm, 44 in.*lbf}

Install the fan and generator V-belt (LandCruiser RM000000YMN02UX.html).

Tighten the 4 nuts of the fluid coupling fan.

Torque:

25 N*m{255 kgf*cm, 18 ft.*lbf}

Attach the claw to close the flexible hose clamp as shown in the illustration.

Install the radiator reservoir with the 3 bolts.

Torque:

5.0 N*m{51 kgf*cm, 44 in.*lbf}

Connect the reservoir hose to the radiator assembly.

Install the upper radiator support seal with the 13 clips.

Start the engine. Make sure that there are no oil leaks from the areas that were worked on.

Warm up the engine, stop the engine and wait 5 minutes.

Check that the oil level is between the dipstick low level mark and full level mark.
If the level is low, check for leakage and add oil up to the full level mark.

NOTICE:

Do not fill engine oil above the full level mark.