Height Control Sensor Inspection


  1. INSPECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH

Height Control Sensor -- Inspection



1. INSPECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH


    Toyota Fortuner. Ggn50, 60 Kun51, 61 Tgn51 Lan50.Lighting.Height Control Sensor.Height Control Sensor Inspection

  1. Check the rear height control sensor sub-assembly LH:

    Text in Illustration
    *a
    		Component without harness connected
    (Rear Height Control Sensor Sub-assembly LH)
    *b
    		Low (-)
    *c
    		Normal
    *d
    		High (+)
    *e
    		Stopper position at lowest vehicle height
    *f
    		Stopper position at highest vehicle height

    1. Connect 3 dry batteries of 1.5 V in series.

    2. Connect the positive (+) end of the batteries to terminal 3 (SHB) of the height control sensor and the negative (-) end of the batteries to terminal 1 (SHG). While slowly moving the sensor link up and down, measure the voltage between terminal 2 (SHRR) and terminal 1 (SHG)

    3. Measure the voltage according to the value(s) in the table below.

      Standard voltage:
      Tester Connection
      		Sensor Condition
      		Specified Condition
      2 (SHRR) - 1 (SHG)
      		High (+)
      		Approx. 4.5 V
      Normal
      		Approx. 2.5 V
      Low (-)
      		Approx. 0.5 V
      NOTICE:
      1. Do not apply a voltage of more than 6 V.
      2. Do not drop the rear height control sensor sub-assembly LH. If it is dropped, replace it with a new one.