Ignition Key Cylinder Light Removal
DISCONNECT CABLE FROM NEGATIVE BATTERY
PLACE FRONT WHEELS FACING STRAIGHT AHEAD
REMOVE STEERING PAD ASSEMBLY
REMOVE STEERING WHEEL ASSEMBLY
REMOVE STEERING COLUMN COVER LOWER
REMOVE STEERING COLUMN COVER UPPER
REMOVE KEY CYLINDER LIGHT ASSEMBLY
Ignition Key Cylinder Light -- Removal |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| 2. PLACE FRONT WHEELS FACING STRAIGHT AHEAD |
| 3. REMOVE STEERING PAD ASSEMBLY |
Straighten the front wheels.
Using a T30 "torx" socket, loosen the 2 screws until the groove along each screw circumference catches on the screw case.
Pull out the steering pad from the steering wheel and support the steering pad with one hand as shown in the illustration.
- NOTICE:
- When removing the steering pad, do not pull the airbag wire harness.
Using a screwdriver, disconnect the airbag connector.
- NOTICE:
- When handling the airbag connector, do not damage the airbag wire harness.
Disconnect the horn connector and remove the steering pad.
| 4. REMOVE STEERING WHEEL ASSEMBLY |
Remove the steering wheel set nut.
Place matchmarks on the steering wheel and main shaft.
Using SST, remove the steering wheel.
- SST
- 09950-50013(09951-05010,09952-05010,09953-05020,09954-05021)
| 5. REMOVE STEERING COLUMN COVER LOWER |
Remove the 3 screws and lower cover.
| 6. REMOVE STEERING COLUMN COVER UPPER |
Remove the 3 screws and lower cover.
| 7. REMOVE KEY CYLINDER LIGHT ASSEMBLY |
Using a screwdriver, detach the claw key cylinder light assembly in the direction indicated by the arrow in the illustration and remove it.
Disconnect the connector.
