Cruise Control System Clutch Switch Circuit
DESCRIPTION
WIRING DIAGRAM
INSPECTION PROCEDURE
INSPECT FUSE (ECU-IG & GAUGE)
INSPECT ECM
INSPECT CLUTCH SWITCH ASSEMBLY
CHECK HARNESS AND CONNECTOR (ECM - CLUTCH SWITCH)
CRUISE CONTROL SYSTEM - Clutch Switch Circuit |
DESCRIPTION
When the clutch pedal is released, the ECM receives positive (+) battery voltage through the ECU-IG & GAUGE fuse. While depressing the clutch pedal, the clutch switch sends a signal to terminal 10(CLSW) of the ECM. The ECM cancels cruise control when terminal 10(CLSW) receives the signal.
WIRING DIAGRAM
INSPECTION PROCEDURE
| 1.INSPECT FUSE (ECU-IG & GAUGE) |
Remove the ECU-IG & GAUGE fuse from the driver side junction block.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
| Condition
| Specified Condition
|
ECU-IG & GAUGE fuse
| Always
| Below 1 Ω
|
Disconnect the E5 ECM connector.
Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
| Switch Condition
| Specified Condition
|
E5-10 (CLSW) - Body ground
| Ignition switch ON
Clutch pedal depressed
| Below 1 V
|
Ignition switch ON
Clutch pedal released
| 11 to 14 V
|
| OK |
|
|
|
| PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE |
|
| 3.INSPECT CLUTCH SWITCH ASSEMBLY |
Remove the clutch switch.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
| Switch Condition
| Specified Condition
|
1 - 2
| Pin pushed
| Below 1 Ω
|
Pin not pushed
| 10 kΩ or higher
|
| | REPLACE CLUTCH SWITCH ASSEMBLY |
|
|
| 4.CHECK HARNESS AND CONNECTOR (ECM - CLUTCH SWITCH) |
Disconnect the E5 ECM connector.
Disconnect the C22 clutch switch connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
| Condition
| Specified Condition
|
E5-10 (CLSW) - C22-2
| Always
| Below 1 Ω
|
E5-10 (CLSW) - Body ground
| Always
| 10 kΩ or higher
|
| | REPAIR OR REPLACE HARNESS OR CONNECTOR (ECM - CLUTCH SWITCH) |
|
|
| OK |
|
|
|
| REPAIR OR REPLACE HARNESS OR CONNECTOR (BATTERY - CLUTCH SWITCH) |
|
