Vane Pump (For 2Tr-Fe) Installation

Install the vane pump with the 2 bolts.

Torque:

21 N*m{214 kgf*cm, 15 ft.*lbf}

Connect the connector to the oil pressure switch.

Install a new gasket and the pressure feed tube to the vane pump with the union bolt.

Torque:

49 N*m{500 kgf*cm, 36 ft.*lbf}

HINT:

Make sure that the stopper of the pressure feed tube touches the front housing as shown in the illustration.

Connect the hose with the clip.

Install the drive belt to all the pulleys except the drive belt tensioner pulley.

Use the hexagon-shaped part indicated by the arrow in the illustration to move the tensioner pulley downward and then install the drive belt to the tensioner pulley.

NOTICE:

1. The backside of the drive belt should face the tensioner pulley.
   
2. Check that the drive belt is properly set to each pulley.
   

After a new belt has been installed, check that the tensioner indicator mark is within range A shown in the illustration.

Perform initialization (Toyota Fortuner RM000002HD2000X.html).

Check the fluid level.

Jack up the front of the vehicle and support it with stands.

Turn the steering wheel.

1. With the engine stopped, turn the steering wheel slowly from lock to lock several times.
   

Lower the vehicle.

Start the engine. Run the engine at idle for a few minutes.

Turn the steering wheel.

1. With the engine idling, turn the steering wheel to the left or right full lock position and hold it there for 2 to 3 seconds. Then turn the steering wheel to the opposite full lock position and hold it there for 2 to 3 seconds.
   

2. Repeat the step above several times.
   

Stop the engine.

Check for foaming or emulsification. If the system has to be bled twice because of foaming or emulsification, check for fluid leaks in the system.

Check the fluid level.