Vane Pump (For 2Tr-Fe) Disassembly

Using SST, fix the vane pump between aluminum plates in a vise, as shown in the illustration.

SST

09630-00014(09631-00132)

Using a 27 mm socket wrench, remove the pressure port union from the front housing.

Using a screwdriver, remove the O-ring from the pressure port union.

Remove the flow control valve from the front housing.

Remove the compression spring from the front housing.

Remove the oil pressure switch from the front housing.

Remove the O-ring from the oil pressure switch.

Remove the 4 bolts and rear housing from the front housing.

Remove the O-ring from the rear housing.

Using a screwdriver, remove the shaft snap ring from the shaft with pulley.

Remove the shaft with pulley from the rear housing.

Remove the 10 vane pump plates from the vane pump rotor.

NOTICE:

Be careful not to drop the vane plates.

Remove the vane pump rotor from the front housing.

Remove the front side plate from the front housing.

Remove the No. 1 O-ring from the side plate.

Remove the No. 2 O-ring from the front housing.

Using a screwdriver, pry out the oil seal.

HINT:

Tape the screwdriver tip before use.