Steering Column Assembly Reassembly

Using a snap ring expander, install a new steering main shaft snap ring (inner side) to the steering main shaft.

Install the steering main shaft to the steering column tube.

Using a snap ring expander, install a steering main shaft snap ring (outer side).

Using SST and a hammer, tap in a new bearing.

SST

09608-06041

Install the solenoid to the steering column upper bracket with the 2 screws.

Install the switch to the steering column upper bracket with the 2 claws.

Install the switch to the steering column upper bracket with the 2 claws.

Make sure that the lock cylinder is on ACC.

Install the ignition switch lock cylinder.

Check that the steering lock mechanism is activated when the key is removed.

Check that the steering lock mechanism is deactivated when the key is inserted and turned to the ACC position.
If there is any abnormality, replace the ignition switch lock cylinder assembly.

Install the steering column upper bracket and steering column upper clamp with 2 new tapered-head bolts.

Tighten the 2 tapered-head bolts until the bolt heads break off.

Connect the connector.

Push in the key cylinder light assembly in the direction indicated by the arrow in the illustration to install it.

Align the amplifier with the installation position of the upper bracket.

Push up the amplifier and connect it to the upper bracket.

NOTICE:

Do not apply excessive force to the amplifier as it may be damaged.

Align the matchmarks on the steering intermediate shaft and steering link.

Install the steering intermediate shaft to the steering link with the bolt.

Torque:

35 N*m{35 kgf*cm, 26 ft.*lbf}

Align the matchmarks on the yoke and steering main shaft.

Install the steering yoke with the bolt.

Torque:

28 N*m{286 kgf*cm, 21 ft.*lbf}