Parking Brake System -- Adjustment |
| 1. CHECK PARKING BRAKE LEVER TRAVEL |
Pull the lever upward with a force of approximately 200 N (20 kgf, 45 lbf) and count the number of clicks.
- OK:
- 7 to 9 clicks (without rear brake dragging)
| 2. REMOVE PARKING BRAKE HOLE COVER SUB-ASSEMBLY |
 |
Detach the 4 claws and remove the hole cover.
| 3. LOOSEN LOCK NUT AND NO. 1 WIRE ADJUSTING NUT |
 |
| 4. REMOVE REAR WHEEL |
| 5. ADJUST BRAKE SHOE CLEARANCE |
| 6. INSTALL REAR WHEEL |
- Torque:
- 105 N*m{1071 kgf*cm, 77 ft.*lbf}
| 7. ADJUST PARKING BRAKE LEVER TRAVEL |
|
Turn the No. 1 wire adjusting nut until the lever travel is correct.
- OK:
- 7 to 9 clicks (without rear brake dragging)
<Lever pulling force: approximately 200 N (20 kgf, 45 lbf)>
Tighten the lock nut.
- Torque:
- 5.2 N*m{53 kgf*cm, 46 in.*lbf}
- HINT:
- If further adjustment is necessary, proceed to the next step.
| 8. ADJUST PARKING BRAKE TURN BUCKLE |
 |
Loosen the lock nut and turn buckle until the lever travel is correct.
Tighten the lock nut.
- Torque:
- 5.0 N*m{51 kgf*cm, 44 in.*lbf}
| 9. INSTALL PARKING BRAKE HOLE COVER SUB-ASSEMBLY |
|
Attach the 4 claws to install the hole cover.