Brake Actuator (For Rhd With Vsc) Removal


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

  2. DRAIN BRAKE FLUID

  3. REMOVE BRAKE ACTUATOR ASSEMBLY

Brake Actuator (For Rhd With Vsc) -- Removal



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Toyota Fortuner RM000004W63000X.html).


2. DRAIN BRAKE FLUID
NOTICE:
Wash off brake fluid immediately if it comes in contact with any painted surface.


3. REMOVE BRAKE ACTUATOR ASSEMBLY


    Toyota Fortuner. Ggn50, 60 Kun51, 61 Tgn51 Lan50.Brake Control.Brake Actuator (For Rhd With Vsc).Brake Actuator (For Rhd With Vsc) Removal

  1. Use tags or make a note to identify the reconnection locations.

    HINT:
    1. *1: to front wheel cylinder RH
    2. *2: to front wheel cylinder LH
    3. *3: to rear wheel cylinder RH
    4. *4: to rear wheel cylinder LH
    5. *5: from master cylinder


    Toyota Fortuner. Ggn50, 60 Kun51, 61 Tgn51 Lan50

  1. Release the latch of the actuator connector and disconnect the connector.

    NOTICE:
    Be careful not to allow brake fluid to enter the removed connector.

  1. Using a union nut wrench, disconnect the 6 brake lines from the actuator.

  1. Detach the brake line from the tube clamp.



  1. Remove the 3 nuts and actuator with bracket.

    NOTICE:
    Toyota Fortuner. Ggn50, 60 Kun51, 61 Tgn51 Lan50
    Be careful not to damage the brake tubes.