Fuel Pressure Regulator Removal


  1. DISCHARGE FUEL SYSTEM PRESSURE

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

  3. REMOVE INTAKE AIR CONNECTOR

  4. REMOVE FUEL PRESSURE REGULATOR ASSEMBLY

Fuel Pressure Regulator -- Removal



1. DISCHARGE FUEL SYSTEM PRESSURE
CAUTION:
  1. Do not disconnect any part of the fuel system until you have discharged the fuel system pressure.
  2. Even after discharging the fuel pressure, place a cloth or equivalent over fittings as you separate them to reduce the risk of fuel spray on yourself or in the engine compartment.

  1. Disconnect the cable from the negative (-) battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag activation.

  1. Remove the front driver side scuff plate.

    1. Using a screwdriver, detach the 7 claws.

      HINT:
      Tape the screwdriver tip before use.

    2. Using a clip remover, detach the 3 clips and remove the scuff plate.



    Toyota Fortuner. Ggn50, 60 Kun51, 61 Tgn51 Lan50

  1. Fold back the floor carpet and disconnect the joining connector, as shown in the illustration.

    HINT:
    This connector has the lines of the fuel pump and rear speed sensor.

  1. Connect the cable to the negative (-) battery terminal.

  1. Start the engine. After the engine has stopped on its own, turn the ignition switch OFF.

    HINT:
    DTC C0210/33 and DTC C0215/34 (rear speed sensor circuit) and DTC P0171/25 (system too lean) may be set.

  1. Crank the engine again, and then check that the engine does not start.

  1. Loosen the fuel tank cap, and then discharge the pressure in the fuel tank completely.

  1. Connect the fuel pump connector.

  1. Install the front driver side scuff plate.

  1. Clear the DTCs (Toyota Fortuner RM000000ZPW007X.html).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag activation.


3. REMOVE INTAKE AIR CONNECTOR

  1. Disconnect the No. 2 ventilation hose.

  1. Disconnect the vacuum hose.

  1. Loosen the 2 hose clamps, remove the 2 bolts and remove the intake air connector.



4. REMOVE FUEL PRESSURE REGULATOR ASSEMBLY


    Toyota Fortuner. Ggn50, 60 Kun51, 61 Tgn51 Lan50.2Tr-Fe Fuel.Fuel Pressure Regulator.Fuel Pressure Regulator Removal

  1. Disconnect the vacuum hose.

  1. Disconnect the No. 2 fuel hose.

    NOTICE:
    Put a suitable container, cloth or equivalent under the fuel delivery pipe.

  1. Remove the 3 bolts and fuel pressure regulator.