Diagnostic trouble code C1268 Land Cruiser

DESCRIPTION

WIRING DIAGRAM

INSPECTION PROCEDURE

CHECK CAN COMMUNICATION LINE

CHECK DTC (CAN COMMUNICATION SYSTEM)

DTC C1268/68 Transfer "L4" Position Switch Circuit

Description

DTC Code	DTC Detection Condition	Trouble Area
C1268/68	The skid control ECU receives an L4 abnormal status signal from the four wheel drive control ECU.	Center differential lock detection switch Center differential lock detection switch circuit Four wheel drive control ECU ECM

Wiring diagram

Inspection procedure

NOTICE:

When replacing the master cylinder solenoid, perform zero point calibration .

1.CHECK CAN COMMUNICATION LINE

1. Turn the ignition switch off.

2. Connect the intelligent tester to the DLC3.

3. Turn the ignition switch to ON and the intelligent tester on.

4. Select "Bus Check" from the System Selection Menu screen, and follow the prompts on the screen to inspect the CAN Bus.

   Result

   Result		Proceed to
   "Bus Check" indicates no malfunctions in CAN communication		A
   "Bus Check" indicates malfunctions in CAN communication	LHD	B
   	RHD	C

   OK:

   "Bus Check" indicates no malfunctions in CAN communication.

B	GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING)
C	GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING)

A

2.CHECK DTC (CAN COMMUNICATION SYSTEM)

1. Turn the ignition switch off.

2. Connect the intelligent tester to the DLC3.

3. Turn the ignition switch to ON and the intelligent tester on.

4. Check for DTCs (LHD: /RHD: ).

   Result

   Result		Proceed to
   CAN system DTC is not output		A
   CAN system DTC is output	LHD	B
   	RHD	C

B	GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING)
C	GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING)

A
GO TO TRANSFER SYSTEM (INSPECTION)