Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - EXTERIOR PANELS / TRIM
ROCKER PANEL MOULDING - INSTALLATION
- HINT:
- Standard Heating Temperature:
Item Temperature Vehicle Body 40 to 60°C (104 to 140°F) Rocker Panel Moulding 20 to 30°C (68 to 86°F)
- NOTICE:
- Do not heat the vehicle body and rocker panel moulding excessively.
| 1. INSTALL BODY ROCKER PANEL MOULDING ASSEMBLY LH |
Clean the vehicle body surface.
Using a heat light, heat the vehicle body surface.
Remove the double-sided tape from the vehicle body.
Wipe off any tape adhesive residue with cleaner.
If reusing the rocker panel moulding:
Clean the rocker panel moulding.
Using a heat light, heat the rocker panel moulding.
Remove the double-sided tape from the rocker panel moulding.
Wipe off any tape adhesive residue with cleaner.
Apply new double-sided tape to the rocker panel moulding, as shown in the illustration.
Install the rocker panel moulding.
Using a heat light, heat the vehicle body and rocker panel moulding.
Remove the peeling paper from the face of the rocker panel moulding.
- HINT:
- After removing the peeling paper, keep the exposed adhesive free from foreign matter.
Attach the 10 clips to install the rocker panel moulding.
Install the 8 side mudguard retainers and screw.
| 2. INSTALL SIDE STEP ASSEMBLY LH |
Install the side step with the 6 bolts.
- Torque:
- 30 N*m{ 306 kgf*cm, 22 ft.*lbf}
| 3. INSTALL FRONT FENDER MUDGUARD LH |
Install the mudguard with the clip.
Using a T30 "TORX" socket, install the 4 screws.