Система Смазки Проверка Без Снятия С Автомобиля. Corolla Auris

Warm up the engine. Then stop the engine and wait for 5 minutes.

Check that the engine oil level is between the 2 marks on the oil level gauge.
If low, check for leakage and top up oil to the upper mark.

ПРИМЕЧАНИЕ:

Do not add engine oil to above the upper mark.

Check the engine oil for deterioration, water intrusion, discoloration and thinning.
If the oil quality is visibly poor, replace the oil.

Remove the engine under cover.

Disconnect the oil pressure switch connector.

Using a 22 or 24 mm deep socket wrench, remove the oil pressure switch.

УКАЗАНИЕ:

As there are 2 kinds of oil pressure switches, select and use either a 22 or 24 mm deep socket wrench as appropriate.

Install the oil pressure gauge.

Warm up the engine.

Check the oil pressure.

Oil pressure:

Engine rpm	Oil pressure
770 rpm	29 kPa (0.3 kgf*cm2, 4.3 psi) or more
3000 rpm	150 to 550 kPa (1.5 to 5.6 kgf*cm2, 22 to 80 psi)

Remove the oil pressure gauge.

Apply adhesive to 2 or 3 threads of the oil pressure switch.

Adhesive:

TOYOTA Genuine Adhesive 1344, Three Bond 1344 or equivalent

Using a 22 or 24 mm deep socket wrench, install the oil pressure switch.

Момент затяжки:

15 Н*м{153 кгс*см, 11 фунт-сила-футов}

ПРИМЕЧАНИЕ:

Do not start the engine for at least 1 hour after installation.

Connect the oil pressure switch connector.

Check for engine oil leakage.

Install the engine under cover.

Remove the engine oil level sensor.

Measure the resistance according to the value(s) in the table below.