Air Switching Valve (For Bank 1) Installation

Install the No. 1 emission control valve set with the 3 nuts.

Torque:

21 N*m{214 kgf*cm, 15 ft.*lbf}

Align the paint mark with the rib and connect the No. 1 air hose.

HINT:

Make sure the direction of the hose clamp is as shown in the illustration.

Connect the No. 1 emission control valve set connector.

Install 2 new gaskets.

NOTICE:

Make sure the gasket's claws are not caught between the No. 1 emission control valve set and air tube.

Install the air tube with the 2 bolts and 2 nuts.

Torque:

10 N*m{102 kgf*cm, 7 in.*lbf}

Install the air cleaner cap and hose.

1. Install the air cleaner cap and hose with the bolt and fasten the 4 hook clamps.
   

   Torque:

   5.0 N*m{51 kgf*cm, 44 in.*lbf}

2. Tighten the clamp.
   

   Torque:

   2.5 N*m{25 kgf*cm, 22 in.*lbf}

3. Attach the clamp and connect the ventilation hose, vacuum hose and mass air flow meter connector.
   

Attach the 2 V-bank cover hooks to the bracket. Then align the 2 V-bank cover grommets with the 2 pins and press down on the V-bank cover to attach the pins.