Lighting System Lvl Terminal Circuit

Body Electrical. Camry. Acv40 Gsv40
Lighting. Camry. Acv40 Gsv40

DESCRIPTION

WIRING DIAGRAM

INSPECTION PROCEDURE

CHECK HARNESS AND CONNECTOR (DLC3 - HEADLIGHT BEAM LEVEL CONTROL ECU)

CHECK HARNESS AND CONNECTOR (DLC3 - BODY GROUND)

LIGHTING SYSTEM - LVL Terminal Circuit


DESCRIPTION

  1. By connecting terminals LVL and CG of the DLC3, the headlight beam level control ECU performs the following:
    1. Initializes the height control sensor signal.
    2. Performs the operation check of the headlight leveling motor.

WIRING DIAGRAM


Camry. Acv40 Gsv40.Lighting.Lighting System.Lighting System Lvl Terminal Circuit


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (DLC3 - HEADLIGHT BEAM LEVEL CONTROL ECU)


    Camry. Acv40 Gsv40.Lighting.Lighting System.Lighting System Lvl Terminal Circuit

  1. Disconnect the A20 headlight beam level control ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    		Condition
    		Specified Condition
    A20-5 (SPDL) - E10-8 (LVL)
    		Always
    		Below 1 Ω
    A20-5 (SPDL) - Body ground
    		Always
    		10 kΩ or higher


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK HARNESS AND CONNECTOR (DLC3 - BODY GROUND)


    Camry. Acv40 Gsv40.Lighting.Lighting System.Lighting System Lvl Terminal Circuit

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    		Condition
    		Specified Condition
    E10-4 (CG) - Body ground
    		Always
    		Below 1 Ω


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE