Rear Crankshaft Oil Seal Installation

Apply MP grease to the lip of a new oil seal.

NOTICE:

Keep the lip free from foreign matter.

Using SST, tap in the oil seal until its surface is flush with the engine rear oil seal retainer edge.

SST

09223-15030
09950-70010(09951-07100)

NOTICE:

Wipe off any extra grease on the crankshaft.

Install the rear end plate with the 2 bolts.

Torque:

27 N*m{275 kgf*cm, 20 ft.*lbf}

Using SST, hold the crankshaft.

SST

09213-54015(91651-60855)
09330-00021

Clean the bolts and bolt holes.

Apply adhesive to 2 or 3 threads of each of the bolts.

Adhesive:

Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

Install the flywheel to the crankshaft.

Temporarily install the flywheel with the 8 bolts.

Tighten the 8 bolts uniformly in several steps in the order shown in the illustration.

Torque:

123 N*m{1249 kgf*cm, 90 ft.*lbf}

NOTICE:

Do not start the engine for at least 1 hour after installing.

Insert SST into the clutch disc. Then insert SST (together with the clutch disc) into the flywheel to install the clutch disc.

SST

09301-00110

Text in Illustration

Flywheel Side

NOTICE:

Be sure to install the clutch disc so that it is facing in the correct direction.

Align the matchmarks on the clutch cover and flywheel.

Tighten the 6 bolts uniformly in the order shown in the illustration, starting with the bolt located near the knock pin on the top.

SST

09301-00110

Torque:

19 N*m{194 kgf*cm, 14 ft.*lbf}

HINT:

Move SST up and down, and right and left lightly after checking that the clutch disc assembly is in the center, and then tighten the bolts.

Install the manual transmission (LandCruiser RM0000048B200AX.html).