Compressor And Magnetic Clutch (For 5L-E) -- Removal |
| 1. DISCHARGE REFRIGERANT FROM REFRIGERATION SYSTEM |
Start the engine.
Turn the A/C switch ON.
Operate the cooler compressor with an engine speed of approximately 1,000 rpm for 5 to 6 minutes to circulate the refrigerant and collect the compressor oil remaining in each component into the cooler compressor.
Stop the engine.
Using SST, discharge the refrigerant gas.
- SST
- 07110-58060(07117-58060,07117-58070,07117-58080,07117-58090,07117-78050,07117-88060,07117-88070,07117-88080)
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag activation.
| 3. REMOVE AIR CLEANER ASSEMBLY |
Disconnect the IAT sensor connector.
Loosen the air cleaner hose clamp.
Remove the 2 bolts and air cleaner.
| 4. REMOVE DRIVE BELT |
Loosen nut A and bolt B, and remove the V belt.
 |
| 5. DISCONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE |
Remove the bolt and disconnect the discharge hose from the compressor.
 |
Remove the O-ring from the discharge hose.
- NOTICE:
- Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.
| 6. DISCONNECT NO. 1 COOLER REFRIGERANT SUCTION HOSE |
Remove the bolt and disconnect the suction hose from the compressor.
 |
Remove the O-ring from the suction hose.
- NOTICE:
- Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.
| 7. REMOVE COMPRESSOR AND MAGNETIC CLUTCH |
Disconnect the connector.
 |
Remove the 4 bolts and compressor.
 |