Fuel Injection Nozzle -- Removal |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag activation.
| 2. DISCONNECT AIR CLEANER HOSE |
Install the air cleaner hose.
Tighten the 2 clamps.
Connect the IAT sensor connector.
| 3. REMOVE INTAKE PIPE ASSEMBLY |
Loosen the intake pipe clamp.
 |
Remove the 2 bolts and intake pipe.
| 4. REMOVE INTAKE FLANGE |
Remove the bolt and clamp of the heater hose.
 |
Disconnect the manifold absolute pressure sensor connector.
 |
Loosen the clamp and then disconnect the ventilation hose.
 |
Remove the 3 nuts, intake flange and gasket.
| 5. REMOVE VENTURI |
Disconnect the throttle open switch connector.
 |
Disconnect the throttle control motor connector.
 |
Remove the venturi and gasket.
| 6. REMOVE INJECTION PIPE SET |
Using a union nut wrench, loosen the 8 union nuts of the 4 injection pipes.
 |
Remove the 2 nuts, 2 upper pipe clamps and 4 injection pipes together with the lower pipe clamps.
| 7. REMOVE NO. 1 GLOW PLUG CONNECTOR |
Remove the nut and disconnect the glow plug connector wire.
Remove the 4 screw grommets, 4 nuts and glow plug connector.
| 8. REMOVE NOZZLE LEAKAGE PIPE ASSEMBLY |
Disconnect the fuel hose from the leakage pipe.
 |
Remove the 4 nuts, leakage pipe and 4 ring packing washers.
| 9. REMOVE NOZZLE HOLDER AND NOZZLE SET |
Using SST, remove the 4 injection nozzles, 4 injection nozzle seats and 4 injection nozzle seat gaskets.
- SST
- 09268-64010(09268-64020)
 |