INSPECT TAIL GATE PANEL SUB-ASSEMBLY

ADJUST TAIL GATE PANEL SUB-ASSEMBLY

ADJUST DOOR LOCK STRIKER

INSPECT BACK DOOR PANEL SUB-ASSEMBLY

ADJUST REAR SWING GATE LOCK STRIKER

ADJUST BACK DOOR PANEL SUB-ASSEMBLY

Check that the clearance measurements of areas H to I are within the standard range.

• Standard Measurement:

• Area	Specified Condition
  H	3.8 to 6.8 mm (0.150 to 0.268 in.)
  I	3.5 to 6.5 mm (0.138 to 0.256 in.)

Loosen the hinge bolts.

Adjust the tail gate by moving it up and down and left and right so that the dimensions are within the specified range.

Tighten the hinge bolts.

• Torque:
• 28 N*m{ 286 kgf*cm, 21 ft.*lbf}

Loosen the hinge bolts.

Adjust the tail gate by moving it up and down and forward and backward so that the dimensions are within the specified range.

Tighten the hinge bolts.

• Torque:
• 31 N*m{ 316 kgf*cm, 23 ft.*lbf}

Using a T40 "TORX" socket, adjust the striker position by slightly loosening the striker mounting screws and hitting the striker with a plastic-faced hammer.

Using a T40 "TORX" socket, tighten the striker mounting screws after the adjustment.

• Torque:
• 12 N*m{ 122 kgf*cm, 9 ft.*lbf}

Check that the clearance measurements of areas A to G are within the standard range.

• Standard Measurement:

• Area	Specified Condition	Area	Specified Condition
  A	5.7 to 8.7 mm (0.224 to 0.343 in.)	E	2.7 to 5.7 mm (0.106 to 0.224 in.)
  B	0.0 to 3.0 mm (0.000 to 0.118 in.)	F	-1.4 to 1.6 mm (-0.0551 to 0.0630 in.)
  C	3.75 to 6.75 mm (0.148 to 0.266 in.)	G	5.0 mm (0.197 in.)
  D	3.75 to 6.75 mm (0.148 to 0.266 in.)	-	-

Check that the door fit and door linkages are adjusted correctly.

Using a T40 "TORX" socket, adjust the striker position by slightly loosening the striker mounting screws and hitting the striker with a plastic-faced hammer.

Using a T40 "TORX" socket, tighten the striker mounting screws after the adjustment.

• Torque:
• 23 N*m{ 235 kgf*cm, 17 ft.*lbf}

Loosen the hinge bolts.

Adjust the back door by moving it up and down and left and right so that the dimensions are within the specified range.

Tighten the hinge bolts.

• Torque:
• 19 N*m{ 194 kgf*cm, 14 ft.*lbf}

Partially remove the roof headlining.

Loosen the hinge nuts.

Adjust the back door by moving it up and down and forward and backward so that the dimensions are within the specified range.

Tighten the hinge nuts.

• Torque:
• 19 N*m{ 194 kgf*cm, 14 ft.*lbf}

Install the roof headlining.